![]() Please download the latest macOS InstantView (R12 and later) from here. One is downloading the latest macOS InstantView from Website. There are two ways to solve this problem. SMI had update macOS InstantView to support MacOS Ventura 13.0 from R12 release. This problem comes from older version (R11 and before) of macOS InstantView is not compatible with upgraded MacOS Ventura 13.0. Therefore, on some platforms, it will cause macOS InstantView damage and can’t be open. The macOS InstantView application makes file copies during installation, which causes its notarization information to be lost with MacOS Ventura 13.0. Reconnecting the cable the whole time is not a good solution too.MacOS Ventura 13.0 enhances the checking of software notarization information in order to improve system security. The problem is that my monitor doesn't have DisplayPort and neither the MacBook Pro has USB-A ports. To overcome this you can either plug in your D6000 with USB-A this will force your device to use DisplayLink at start or you can plug in your monitor into the DP port if possible.īeside this you can try as you did re-plugging because it is the OS that decides which technology got the priority. Due to it you may see the information that the monitors are not detected.ĭisplayLink chipset is responsible for bringing two DP monitors and if needed cooperate with Alt-mode when more than one monitor is connected. When the Alt-mode technology is active the 2nd part of the docking station (DisplayLink) is not working at start if it is not needed. Alt-mode is responsible for raising HDMI monitor (the only one you use in your case). One of them is called Alt-mode it is only working when you are using USB-C. The case with D6000 is that it is using two technologies. In contact with DisplayLink support, I have received this answer: I've searched but found nothing about these specific issues with macOS. After this, a new audio device is shown (Dell USB Audio) and I can disconnect the 3.5mm cable and connect again without needing to reconnect the whole dock. This hack only works if the cable is already connected before I unplug the dock. Both don't work, but, similarly to the Ethernet problem, it does work if I unplug and plug the dock again after macOS has booted. This dock has both a 3.5mm audio out on the back and a 3.5mm headset (in/out) on the front. It just doesn't work when I boot the MacBook with the dock already connected. What I found out is that if I disconnect the entire dock from the MacBook and connect it again, it does work, it shows the Ethernet adapter as connected. Unplugging and plugging the cable again does not fix it. It does show up on Network settings, but it shows as disconnected. The first one is that Ethernet does not work. In short, I had to reboot while Sound settings window was open (makes no sense), but it worked, now I have the LG ULTRAWIDE audio output device and sound is working fine through HDMI.īut now I have two more problems. ![]() I noticed that no sound was coming through HDMI and in Sound settings there was no HDMI output device. Even though the display was already working, I've installed DisplayLink drivers anyway. When I connected the dock for the first time through USB-C, the MacBook already started to charge and my LG Ultrawide monitor was being displayed as a second screen, no problems there. I've recently bought an M1 MacBook Pro and I'm trying to use a Dell D6000 dock that I already had for Windows/Linux laptops. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |